These are replacement washers from Traxxas. Features: Black plastic construction Used on the axles and in the transmission Includes: Twenty washers Specs: Size: 5x8mm Thickness: 0.5mm

These are the replacement rear wheel adapters for the Hawk, Hawk 2, Bullet, Sledgehammer, Eagle, and Blue Eagle LS. These are hex nuts that connect the rear wheels to the axles. Includes: Two plastic hex collars (wheel adapters) Four stub axle pins

Traxxas LED light kits are built tough, with factory fit and finish for easy installation. Designed specifically for Slash 4X4 models, the kit includes 4 brilliant white forward-facing LEDs and two rear-facing red LEDs to enhance rear visibility.

These are 3mm threaded rods by Traxxas. Features: Steel Shafts Includes: One 20mm Shaft One 25mm Shaft One 44mm shaft

Traxxas Rustler 4x4 Light Kit with Front and Rear Bumpers. These replacement bumpers is intended for the Traxxas Rustler 4x4. Four LEDs are installed to the front bumper and two LEDs are installed to the rear bumper.

Replacement rear shock tower nitro rustler

This is a front bumper with bumper support by Traxxas.

This is a pair of Traxxas Aluminum Left/Right Caster Blocks (C-Hubs) in Green.

This is a pair of orange-anodized 6061-T6 aluminum left and right c-hubs caster blocks by Traxxas.

This is the Traxxas speed bit essentials set with 7-piece hex and nut driver. Includes: Premium handle (medium) travel pouch Hex drivers Straight: 1.5mm 2.0mm 2.5mm Nut drivers: 5.0mm 5.5mm 7.0mm and 8.0mm 1/4” drive

This is a package of three air filter/pre-filter foam inserts for the Traxxas .20 cu in (3.3cc) racing engine.

This is a pack of two replacement Traxxas 6x12x4mm Ball Bearings.