This is a replacement flyweehl nut for the Traxxas 2.5 and 2.5R engines that use an SG shaft. This is the same nut that comes with the Traxxas Revo.

This is the cooling head protector for the Traxxas TRX 3.3 Racing Engine.

This is a replacement one way clutch bearing for Traxxas monster trucks such as the Traxxas Revo. This is the one way bearing that attaches the pull start or EZ-start assembly to the back of the crank shaft in the TRX 2.5 engines and TRX 3.3 engines.

This is the suspension screw pin set for the Traxxas T-Maxx 3.3.

This is a package of 24 1.5mm E-Clips from Traxxas.

Traxxas bellcrank set is constructed of black composite nylon. Replaces a worn or damaged bellcrank set. This will also work as an upgrade for the Nitro Maxx Series and the E-Maxx.

Traxxas updated stock replacement fuel tank is made of clear, nylon construction. Black fuel tank cap (spring loaded). This fuel tank is unique to the T-Maxx and is not known to fit any other vehicles.

Traxxas set of hex wheel hubs for the T-Maxx 4WD RTR Monster Truck. These wheel hubs fit on the end of the stub axles. Replaces missing or damaged hex wheel hubs. Hubs are made of molded black plastic.

This is the set of axle pins for the Traxxas T-Maxx 4WD RTR Monster Truck. These pins go through the stub axles on each wheel, the wheel hubs are then placed over these pins.

Traxxas optional wheelie bar for all Traxxas Maxx series is constructed of hardened plastic, black in color. Installs at rear of chassis to prevent vehicle from flipping over during wheelies

These are the lower suspension arms for the T-Maxx 3.3.

Traxxas replacement backplate for the 2.5 engine. This backplate is used on the 2.5 equipped with EZ starter. NCLUDED: One Alum backplate with pre-installed bushing. Requires: Installation onto 2.5 engine