32 pitch pinions precision cut from hard steel alloy, lightened for reduced weight. 1/8 inch bore. One 5-40 set screw included.

Robinson Racing Extra Hard Steel 5mm Bore .8 Mod Pinion Gears fit brushless motors with a 5mm shaft and are intended for use with the Traxxas E-Maxx model #3905.

This is a package of 24 1.5mm E-Clips from Traxxas.

Traxxas bellcrank set is constructed of black composite nylon. Replaces a worn or damaged bellcrank set. This will also work as an upgrade for the Nitro Maxx Series and the E-Maxx.

Traxxas updated stock replacement fuel tank is made of clear, nylon construction. Black fuel tank cap (spring loaded). This fuel tank is unique to the T-Maxx and is not known to fit any other vehicles.

Traxxas set of hex wheel hubs for the T-Maxx 4WD RTR Monster Truck. These wheel hubs fit on the end of the stub axles. Replaces missing or damaged hex wheel hubs. Hubs are made of molded black plastic.

This is the set of axle pins for the Traxxas T-Maxx 4WD RTR Monster Truck. These pins go through the stub axles on each wheel, the wheel hubs are then placed over these pins.

These are the lower suspension arms for the T-Maxx 3.3.

Traxxas replacement backplate for the 2.5 engine. This backplate is used on the 2.5 equipped with EZ starter. NCLUDED: One Alum backplate with pre-installed bushing. Requires: Installation onto 2.5 engine

Traxxas large rod end Set for the Traxxas Revo. 

This is a package of replacement caster spacers for the Traxxas 2.5 T-Maxx. These spacers adjust caster of the wheels.

This is a replacement slipper pressure plate and slipper hub for the Revo. These are part of the slipper assembly.