This is an optional RPM Motor Protector, and is intended for use with the Traxxas Slash, Bandit, Stampede and Rustler vehicles.

This is an RPM no-clip body mount set for the Traxxas Slash 2WD.

This is a set of optional RPM Axle Carriers, and are intended for use with the Traxxas 1/16 E-Revo and 1/16 Slash trucks. There is very little that can be as frustrating on an R/C vehicle as slop in the suspension system.

This is a set of RPM Front Upper & Lower A-Arms, and are intended for use with the Traxxas 1/16 E-Revo.

RPM X-Maxx Low Visibility Wheelie Bars are designed to take the stress off of the low hanging rear bumper whenever the rear end wants to drag on the ground.

Similar to our original Losi Baja Rey front bumper (RPM #73742), our newest iteration of the Baja Rey front bumper is designed to work with the Ford Raptor body from Losi.

RPM skid plates, unlike the stock center skid plate, our new molded center skid plate extends over the predominance of the chassis rails with better than 4mm of bulletproof RPM protection!

This is the RPM wheelie bar mount for the Traxxas Rustler 4x4. RPM eliminated the rear bumper / wheelie bar entirely! Instead, RPM opted for more adjustability and a solid mount that allows a wheelie bar to work properly.

These are the optional RPM wide front A-arms for the Traxxas Electric Rustler and 2WD Stampede.

RPM rear shock towers for the electric versions of the Stampede, Rustler, Slash & Bandit were designed with one thing in mind rugged durability.

Let’s face facts. If you own an X-Maxx, there’s a good chance you’re going to wind up on your lid. 19+ lbs. (8.6+ kgs.) will rip through that thin lexan body in no time at all if you don’t find a way to protect it. That’s where RPM steps in!

RPM has proven time after time that even the most experienced drivers cannot set their camber by eye.